The 401 was available in the javelin matador and ambassador car lines and in jeeps from its introduction in 1971 through 1974.
Amc 401 rod length.
All molnar rods are finished in the united states at the molnar technologies shop in michigan.
Information about amc engines and their specifications.
The 401 has 2 090 inch rod and 2 248 inch main journals which means you can swap the.
That is 250 off the rocker bosses and the thickness of the guideplate to center the tip of the roller.
Getting 500 lb ft and more than 480 horses from an amc 401.
Amc 360 rods 390 rods 401 connecting rods and amc stroker rods.
These rod sets come complete with 8 rods 7 16 arp 2000 rod bolts installation instructions and assembly lube molnar amc engine rod sets listed below have the correct amc rod beam offset.
Getting 500 lb ft and more than 480 horses from an amc 401.
C c length of rod center to center in inches.
Pin wrist pin size that rod is designed to work with.
These rod sets come complete with 3 8 arp 2000 rod bolts installation instructions and arp moly lube.
Like the 390 factory recommended overbore is only 0 020 in 0 51 mm but commonly bored by 0 030 in 0 76 mm.
These specifications were produced in the early seventies.
Amc 360 390 401 rods.
But hope to soon.
Some folks if anal enough will start slightly off center.
K1 amc engine rod sets listed below have the correct amc rod beam offset.
Rod jrnl crankshaft rod journal diameter in inches.
Stock 5 858 rod bearings.
View this page as large as possible and under high resolution for best results.
Bore rod big end housing bore diameter in inches.
We have rods available for the amc 360 390 and 401 engines with stock stroke crankshafts and also special amc stroker rods 6 000 inch long for use with either a 2 000 inch or 2 100 inch crankshaft rod journal size as used on many amc stroker cranks.
I do not have current numbers at this time.
The 70 tall deck amc 390 has a unique piston and rod combo that makes it different from the 68 69 variety.
Engine specific production specifications for 360 401 engines.
Like the 390 the 401 s crankshaft and connecting rods are forged steel.
